Current position: Home > Shortcut to A > A05 Series

Note 2: The algebraic convention, where the most negative value is a minimum and the most positive value a maximum, is used in   this data sheet. Note 3: Guaranteed by design. Note 4: ∆RON = RON(MAX) - RON(MIN). Note 5: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the   specified analog signal range. Note 6: Leakage parameters are 100% tested at maximum-rated hot temperature and guaranteed by correlation at +25C. Note 7: Off-isolation = 20 log10 [VCOM / (VNC or VNO)], VCOM = output, VNC or VNO = input to off switch. Note 8: Between any two switches. Note 9: Leakage testing at single supply is guaranteed by testing with dual supplies.
A heatsink is required to keep the junction temperature below absolute maximum rating when an output is heavily loaded or shorted. See Absolute Maximum Ratings section for more information. Approximately 0.5 mA (total) flows from VCC+ to GND for internal logic control bias. Slew rate is defined from the 25% to the 75% output levels.
The LNA has a 2.4dB typical noise figure and a -10dBm input third-order intercept point (IP3). The downconvert- er mixer has a low 9.2dB noise figure and 4dBm input IP3. Image and local-oscillator filtering are implemented off-chip for maximum flexibility. The PA driver amplifier has 15dB of gain, which can be reduced over a 35dB range. Power consumption is only 60mW in receive mode and 90mW in transmit mode and drops to less than 3µW in shutdown mode. For applications requiring separate, single-ended IF input and output ports, refer to the MAX2410 data sheet. For applications requiring only a receive func- tion, Maxim offers a low-cost downconverter with LNA (see the MAX2406 data sheet).